Damperli yarı römork

FLIEGL 3-Achs Alu Kipper DHKA 390 - 50m³

The images are archive photos. The vehicle may still be in use.

Chassis – Tipper Semi-Trailer
Fine-grain steel welded construction, in basic lightweight design, fifth wheel plate with replaceable 2" kingpin.
Curved front wall "Patented"
24 t, two-speed landing gear, single-side operation, straight lower section, without load compensation.
2x wheel chocks with holders
Aluminum side underrun protection
Folding rear underrun protection
6x half-shell mudguards
Integrated "mudguard holder" with stone-repellent surface
Tarp support bar with holder
2x tow hooks at rear

Axles & Suspension
BPW disc brake axles
"Axle/chassis laser-aligned" for reduced tire wear and fuel consumption
Air suspension
1st axle with automatic lift axle, including forced lowering and start assist, operated by triple brake application

Brake System
2-line air pressure brake system
Bwjdpfx Aisy Efcushou
Color-coded lines for easy servicing
Spring-loaded parking brake
2 foolproof couplings at front, without connecting line
EBS, Electronic Brake System with EBS socket at front, without connection cable
Note: The trailer may only be towed by vehicles that can guarantee the effectiveness of ABS!
With lifting & lowering valve
Vehicle Stability Control System

Wheels and Tyres
6x 385/65 R22.5"
6x steel rims

Electrics
24 Volt, multi-chamber lights, lateral yellow LED lighting
2 white marker lights at front
2 white/red clearance lights at rear
2 x 7-pin and 1 x 15-pin foolproof sockets at front, without connection cable

Hydraulics
Low-pressure cylinder max. 170 bar, smallest stage hard-chromed, with HDK screw coupling, fixed part, NW 48 mm.
(without hose connection)

Body
Aluminum box-type body made of high-quality, wear-resistant material.
Sloped front wall, 5 mm thick, with external cylinder mount.
Side walls made of 30 mm hollow chamber profiles, cleanly welded, with bulk material-repellent top rail. Inside fitted with access at the front wall.
Shovel and broom holder on the outside of the front wall.
Rear wall with pendulum mount, "double joint hinge," split 1/2 to 1/2 with two-wing door, top with swing-out support, each door with grain chute.
Rear wall with rubber seal
Continuous 6 mm floor
Standing platform with access, connection plate for air/electricity and brake. Roll tarp stowable on the right-hand side, with central locking on the left-hand side.

Operating Notes
For transports of salt, lime, etc., we recommend a tipping cylinder with a hard-chromed piston rod to avoid corrosion damage.
The specified gross weight is technically possible. Depending on the load type, the permissible axle/support/kingpin loads may restrict the achievable total weight. (Incorrect load distribution can cause poor handling and tracking.)
Note: Not suitable for chemically aggressive materials (e.g., acids, chlorinated compounds, sulphur compounds, "refuse-derived fuels"). Such media, particularly on moist body surfaces, may lead to stress corrosion cracking and severe fractures in the body structure!
Vehicles with tipper bodies are intended for non-aggressive loads. Use for transport of aggressive substances such as acids, bases, salts, fertilizers, sewage sludge, and domestic waste is at the owner's risk. This may result in stress crack or pitting corrosion damage.

The images are archive photos!

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.