Alçak yükleyici

Fliegl TPS 118 Bau m Heckanschrägung

Further Information

Chassis Central Axle Trailer
Fine-grained steel welded construction
6 pairs of lashing eyes bolted to the exterior floor/frame, each rated at 5t
2 additional pairs of lashing eyes bolted to the floor in the corners, each rated at 5t
Front support leg, gearbox type
Foldable rear support
2 wheel chocks with holders
Steel underrun protection
Full-width rear mud flaps
Quarter mudguards
Gksdpfji Rixrjx Aggod
1 plastic toolbox with shelf, dimensions b=620/h=360/d=440 mm, lockable with a padlock (padlock not included)
Drawbar Central Axle Trailer
Drawbar with tested 40 mm towing eye
Height-adjustable drawbar via spindle, max. adjustment range 300 mm
Axles & Suspension
Drum brake axles as per manufacturer's specification
Axle/chassis laser alignment for reduced tyre wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bushings and mechanical axle load compensation (balancing rocker)
Wheels and Tyres
235 / 75 R 17.5
as per manufacturer's specification
Factory silver steel rims
Brake System
2-line compressed air brake system
Hand spindle parking brake
Integral air reservoir
2 non-interchangeable coupling heads at front with connecting lines to the tractor
ABS and ALB, with ABS socket at the front and connecting cable
Electrics
24 Volts, multi-chamber lights, side yellow LED lighting
2 white position lights at the front
2 white/red lane marker lights at the rear
2 x 7-pin non-interchangeable sockets at the front, with connecting cable
Floor
Steel chequered plate floor for high point load capacity
Note: Slight floor undulation due to welding distortion possible!
Platform length approx. 5,200 mm
Rear taper approx. 900 mm
Front wall / corner posts
25 mm aluminium hollow profile, 400 mm high
Side walls
25 mm aluminium hollow profile, 400 mm high, foldable and removable
Rear wall / rear corner posts
1 pair steel posts fixed to the frame with holders to secure loading ramps, clear entry width approx. 2,430 mm
Loading ramps
2 steel ramps, 2,300 mm long, 510 mm wide, laterally adjustable with hand grip on ramps
Surfaced with 3 serrated steel tracks
Gas strut support for single person operation
Registration Country/ Plates
Registration country: Germany
24/7 service hotline
Prepared for single-line licence plate holder
Contour marking with reflective tape as per ECE R 048, white at the sides and red at the rear
Paintwork
Frame hot-dip galvanised including passivation
15-year warranty against rust-through
Front wall aluminium
Side wall aluminium anodised
Loading ramps hot-dip galvanised
Note: These are archive images.

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.