Platform açık

Fliegl TPS 200 Jumbo Z

Further information
Chassis central axle trailer
Fine-grain steel welded construction
Type TPS 200 (special permit required)
Gear support leg at front
Rear support can be folded
Wheel chocks with holders
Side underrun protection made of aluminium
Full-width rear mud flaps
Mud flaps in front of each axle and anti-spray mud flaps behind each axle
1x spare wheel holder for 1 spare wheel, with wheel fixing kit
1x spare wheel, same make as standard tires, steel rim
1x stainless steel toolbox, w=600/h=400/d=500 mm, with polished lockable door
Lashing points low loader
5 pairs of stake pockets recessed in the outer frame, inside 70 x 40 mm, (convertible to 5t lashing rings, not included)
7 pairs of lashing mushrooms recessed on the top and side of the outer frame, each rated at 10t
2 pairs of folding lashing rings additionally recessed in the low bed area, each 10t (1 pair at the front and 1 at the rear slope)
Drawbar system for central axle trailer
Drawbar with certified 50 mm towing eye
Axles + Suspension
SAF drum brake axles
Laser-measured axles/chassis to reduce tire wear and fuel consumption
Axle spacing 1810 mm (then 10t axle load technically permitted)
Air suspension
Braking system
2-line compressed air brake system, color-coded lines for easy servicing.
Spring-loaded parking brake
Duomatic coupling at front, with connecting line to tractor unit
EBS electronic brake system with EBS connector at the front, including connection cable
Note: The trailer may only be towed by towing vehicles that ensure the functionality of the ABS!
With lift & lower valve
Vehicle – driving stability system
Axle load detection via EBS CAN bus signal, for display in the cabin, truck needs appropriate preparation, not installed in the truck (not a calibrated scale)
Wheels and tires
235/75 R17.5, make: Fulda
Steel rims, factory silver
Electrics
24 volt, multi-chamber lights, yellow side LED lighting
2 white position lights at the front
2 white/red lane marker lights at the rear
1 x 15-pin connector at front including connecting cable
1 additional LED work light at rear, switched via reverse light
1x LED beacon with bracket, powered by position light (removable beacon)
Floor
Subsequently finished with 70 mm softwood floor, wheel arch area with steel/chequer plate cover
Rear incline with Mega Grip surface made from serrated grating
Low bed area including rear incline 6500 mm
Rodpfx Aep N Dguogpet
Front wall / corner stanchions
25 mm aluminium hollow profile, 400 mm high, detachable
Loading ramps
Steel ramps 3600 mm long, 750 mm wide, split by cable tensioning, laterally adjustable
Ramp displacement: min. spacing approx. 600 mm, max. outside width approx. 2880 mm
Ramp surface with Mega Grip made from serrated grating
Operated hydraulically by separate electrohydraulic unit, mounted in steel box, controlling located on right-hand side. Note: NATO socket with connection cable on truck required. Connection cable must not be connected while driving!
Hydraulic lateral displacement of ramps, individually controllable (only in conjunction with hydraulic ramp actuation)

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.