Termoform makinesi

Illig UA 100 4G Solo/ BE

Maximum forming area: 960 x 660 mm
Minimum forming area: 210 x 170 mm
Maximum sheet size: 1000 x 700 mm
Minimum sheet size: 310 x 210 mm
Maximum sheet thickness, manual feed: 12 mm
Maximum sheet thickness, automatic feed: 10 mm
Maximum tool height: 490 mm
Maximum draw depth: 300 mm pos./neg.
Total connected load approx.: 64.0 kW / 115 A

Technical equipment:
- Control system Siemens Simatic S7-300, panel OP 37
- Control cabinet with climate control
- Top heating: 5 temperature control circuits via pilot emitters
- Bottom heating: 5 temperature control circuits via pilot emitters
- Top heating with individual emitter switching
- Bottom heating with individual emitter switching
- Parallel clamping frame
- Locking of the upper reduction frames via pneumatic motor
- Locking of the lower reduction frames via cylinder
Gijdpfxjwf Dvas Apqeu
- 4 cooling fans
- Table vacuum adjustable via cascade control
- Pre-blow / demoulding adjustable via cascade control
- Large front opening for tool change
- Sag control of film by photocell with support air
- Automatic tool change system

Lower table:
1. Tool clamping via vacuum
2. Tool change via pneumatically actuated ball rollers

Upper punch:
1. With motorized remote adjustment for stroke limitation
2. Pneumatic quick-change tool clamping system

Sheet feeding:
- Automatic lifting of the film transport chain by motor
- With pneumatic quick-clamping system for suction plates
- Motorized centering of plastic sheets
- Separate vacuum pump for embossed material

Optional retrofitting pre-heating:
- Top heating, pneumatically actuated, fieldwise control, emitters can be switched on/off individually by toggle switch
- Bottom heating, pneumatically actuated, fieldwise control, emitters can be switched on/off individually by toggle switch
- Temperature control for top and bottom heating via separate controllers integrated in BE switch cabinet (temperature cannot be set via UA control panel)

Optional retrofitting for roll processing:
- Cross cutter and feed rollers integrated into the feeding system
- Roll stand RO 800

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.