Ağaç parçalayıcı

die magnetprofis Winkelförderband Z-Förderband

Aluminum Z-shaped conveyor belt with substructure, including adjustable feet and omnidirectional transport casters with locking brakes.

Horizontal section: 800 mm
Inclined section: 3,000 mm
Second inclined section: 1,200 mm
Angle at each bend: 60°
Total conveyor belt length (measured on the floor): 3,500 mm

Height of the horizontal section: 400 mm

Design:
- Aluminum construction profile, double-reinforced 90x45 mm
- Full-surface discharge plate, 2.0 mm galvanized
- Drive drum and tail drum: S235 steel, welded and machined
Ø100x720 mm, crowned and precision-turned, shaft mounted on pillow block bearings.
- Drive: Mounted gear motor, 1.10 kW, belt speed: 0.53 m/sec
- Electrical connection: 230/400V, 50Hz, protection class IP54
- Drive supply cable pre-installed up to the motor terminal box
(Commissioning must be carried out by a qualified electrician)

Dkodpfjyhzhnsx Afmjh
PU conveyor belt DM 10/2 0+005 PU with wave edge, petrol matte finish, AS (anti-static), especially laterally rigid with a hard cover
- Conveyor belt width: 700 mm
- 2 pcs. wave edges, 50 mm high, 25 mm wide, high-frequency welded
- 34 pcs. T40 cleats, centrally positioned, 430 mm long, spacing approx. 299 mm
- Belt material: 2-ply, extra laterally rigid
- In the bend area, the belt is guided on each side by 3 hold-down rollers

The belt is manufactured with a 70 mm edge-free zone on both sides.
Due to the wave edge on both sides, the usable belt width is reduced:
Usable width: 500 mm, calculated as follows:
(Top view) cross arrangement: 70+25+5+500+5+25+70 mm

Belt guidance via PVC V-guide on the running surface, profile 10x6 mm
- Including cut-out in the discharge plate
- Including slide bearings in the drive and tail drums.

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.