Alçak yükleyici

Fliegl SDS 510 mit Tiefbett

Customised Transport Solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are tailored individually to customer specifications.

Chassis Low Loader Semi-Trailer
Steel welded construction, fifth wheel plate with replaceable 2-inch kingpin
24 t two-speed landing gear, single-side operation, with straight lower part, without lateral compensation
Rear support foldable
2x wheel chocks with holders
Aluminium side underrun protection
Quarter shell mudguards in front of and behind axle assembly
With mud flaps behind each axle
1x storage box, width = 2,350 mm x length = 730 mm x height = 640 mm, mounted transversely at the front on the swan neck floor, with 2 storage trays
Extendable widenings to 3,000 mm (not at the rear chamfer) (Track width of machines or vehicles to be transported must not exceed outer frame width of 2,550 mm)
Storage compartment for timber planks on the swan neck, front transverse
70 mm timber planks for extension to 3,000 mm
Excavator trough starting over the rear axles to the tail, approx. 500 mm wide and approx. 230 mm deep
Lashing eyes low loader
3 pairs of lashing eyes each 10 t at front swan neck, 8 pairs each 10 t in the low bed, 3 pairs of lashing rails in the driving lane area of the low bed, 3 pairs of lashing eyes each 10 t in the axle/rear area
Axles & Suspension
SAF drum brake axles
Csdpfsi Ri Hgox Adpsgu
Axle/chassis laser-aligned for reduced tyre wear and fuel consumption
With steering axle
Air suspension
Wheels and Tyres
235 / 75 R 17.5
At manufacturer's discretion
Steel rims in twin arrangement, factory silver
Brake System
2-line compressed air brake system, colour-coded piping for easy service.
Spring-loaded parking brake
EBS, electronic braking system with EBS socket at the front, without connection cable
Note: Towed vehicles must only be pulled by tractor units that ensure the effectiveness of ABS!
2 non-interchangeable coupling heads at the front, no connection line
With raise & lower valve, hold function in down position + auto-reset function
Axle load sensing via EBS CAN bus signal, display in cab requires suitable truck preparation, not installed (not a certified scale)
Vehicle Stability System
Trailer Info Center, for displaying vehicle data such as axle loads (not a certified scale), mileage, and diagnostic/system messages.
Electrics
24 Volt, multi-chamber lights, side yellow LED lighting
2 front white position lights in LED
2 rear white/red lane marker lights
2 x 7-pin non-interchangeable sockets at the front
1x additional LED work light at the rear
1x LED beacon with bracket, controlled via side lights
2 pairs of warning panels, double LED illuminated and extendable to 3,000 mm
Floor
Swan neck with steel / chequer plate covering
In the lane area with 70 mm softwood floor, in the wheel arch area with steel / chequer plate covering, low bed left and right in the lane area can be hydraulically lifted for entry, via truck PTO
Rear chamfer with 70 mm softwood floor
Low bed length approx. 6,300 mm
Side Walls
25 mm aluminium hollow profile, 400 mm high, insertable at the front and sides on the swan neck
Ramps
Steel ramps, 2,800 mm long, 750 mm wide

Customised Transport Solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are tailored individually to customer specifications.

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.