CNC işleme merkezi

Holzfraese HP 1890

Used machine

Year of manufacture: 2019

Only 110 operating hours!

Features and technical data:

X = 1800 mm
Y = 900 mm
Z = 80 mm

Constructed from 18 mm Koskisen boards, consisting of a milling table (X-axis), a gantry (Y-axis), and a Z-axis.

Milling bed made from 19 mm MDF as a sacrificial board, equipped with guide rails and T-slot nuts for clamping.

Base frame with reinforcements, filled with polymer concrete, prepared for transport by pallet jack or forklift.

Mechanical set consisting of profile linear guides including guide carriages, and ball screws 2010 and 1605 for all axes.

Shaft couplings and high-performance grease for lubricating the individual carriages, as well as energy chains including connection sets.

Control set consisting of a Triple Beast for controlling 3 axes, with Ethernet connection.

Leadshine amplifier for the fourth motor. Four stepper motors, 5.0 A, 3 Nm, including motor cables, as well as power supply unit with 48 V, 6.7 A, breakout board with LED circuit board, ribbon cables and proximity sensors, small parts such as wire leads, wire end sleeves, control cables, heat shrink tubing, and cable lugs.

Completely installed in an aluminum housing, including electrical kit and emergency stop.

21.5 inch monitor as built-in display, including mini PC with Windows 7, CAD software Rhino 5.0, G-code generator Estlcam, control software Beamicon2, as well as mouse and keyboard, pre-installed in an ergonomic control console.

Tool length sensor for determining tool length and updating the active reference offset.

Special equipment:

Dedow Nadyopfx Ag Eeuu
High-frequency spindle with 2.2 kW, including clamping nut, frequency inverter, mains filter, brake resistor, and collet set.

PC with 8 GB RAM and AMD processor

CAD software Rhino 5.0 for creating both simple 2D data and 3D solid models

Availability: short-term
Location: Flörsheim

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.