Vinç kamyonu

Volvo FH 540 8x2 Crane truck w/ 165 t/m HIDROKON crane w

Contact ATS Norway for more information.

Please quote the reference number upon request: 20511

Specifications:

- Model year: 2021
- 5,874 km (will increase slightly)
- EU approval valid until: 21.02.26
- Euro 6 engine
- 8x2
- 551 hp
- Suspension on 1st and 2nd axle: steel
- Suspension on 3rd and 4th axle: air
- 2 x 110-liter variable displacement pumps
- 2 x manual extensions for main boom and 2 x for jib
- Scanreco remote control (top model)
- Load cell on main boom
- Additional sheave on main boom and jib
- Automatic leveling (the vehicle levels itself and is ready for lifting)
- Virtual space (option to limit all axles at the push of a button, no need for a workshop—ideal for working under high voltage, etc.)
- SKF central lubrication ring and up to the first section
- Additional sheave up to the top of the boom
- Single winch hook (jib / main boom)
- 2 auxiliary winch hooks (boom / main boom)
- 4-point winch hook (main boom)
- Hook for jib
- Large hook for main boom
- Lowering the generator (24 Volt)
- Cable stop sensor and sleeve
- 4-ton winch
- Diagnostic cable for online assistance (remote support)
- Danfoss valve center
- 2 x 2-ton counterweights (Only used for cranes above the cab—otherwise, counterweights are not needed and can be removed if required)
- Front support leg

Bodywork:

- 4 x work lights, strategically placed in each boom cabinet.
- 50" LED work light at the rear of the cab
- Powerful LED lights on the crane.
- VBG mounting, with air servo control unit mounted on the left side of the rear cabinet.
- Roof rack
- 2 LED light bars mounted at the front of the roof (daylight!).
- Amber working LED warning light on the roof.
- EasyUp folding ladder with side handrail.
- Chain storage boxes, etc. mounted to the rear support legs, allowing for simultaneous extension and secure transport while driving.
- Charger for controls inside the cab
- Plastic inner fenders for axle 3 and 4
- Triangular pull-out compartment between axles 3 and 4
- On the left between axles 2 and 3 is a large locker with a 500 W heater, suitable for drying clothes, etc.
- Flat/lower closed rear with alloy aluminum door panels precisely cut to fit the vehicle, with rounded edges for a very professional appearance.
Knjdpfjwphixex Ahwof
- CNC-manufactured panels at the rear of the cab.
- Sides, cabin, and rear fully painted.
- Crane boom cradle for operation without boom.
- 5 outrigger pads. 4 pieces, 80x80x6 cm, stored in purpose-built holders at the rear.
- Large right-side locker, 1.2 x 1 meter
- High-performance LED reversing/work lights.
- The rear of the vehicle has been rebuilt with CNC-manufactured panels and modern LED taillights installed in several steps.
- Strategically placed hatches for access to key equipment under the body.
- Precisely cut...

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.