TORNA

Optimum TX5216V Vario

Optimum Optiturn TX 5216V – used machine.

- Machine bed made from heavily ribbed cast iron
- One-piece machine base made from steel
- High rigidity of the headstock housing due to heavily ribbed 25GG cast iron
- Precision-machined carriage
- Shafts run on needle bearings; all components are lubricated in an oil bath
- Bed guides are hardened and precision ground
- All electronic controls are centrally accessible
- All feed gearbox gears made of hardened steel
- Handwheels decoupled and tested according to EN 23125
- Dual-channel safety electronics
- Switches with lifecycle calculation, tested in accordance with EN ISO 13849
- Fully covered leadscrew and feed shaft
- Fully illuminated work area
Gujdjx Hdq Tjpfx Aaxsk
- Service-friendly, removable rear panel
- Hardened and ground faceplate spindle ensures exceptional accuracy and durability
- High chip removal rates in roughing operations thanks to large machining capacity
- Energy chain provides gentle cable and hose guidance
- Lockable chip guard travels with bed carriage, integrated position indicator and coolant hose, manually adjustable
- No change gears required
- Safety device prevents simultaneous operation of threading and feed mechanisms
- Electronic Z-axis feed cut-off
- Coolant system with separate coolant tank featuring level indicator and oil separator; easy and complete draining and cleaning according to DIN
- Electric position stop with quadruple position stop
- Three-jaw chuck included as standard
- SWH 7-C quick-change tool post
- Tool holder 32 x 130 Type D for 25 mm square tool bits
- Large spindle bore

Dimensions and Weights
Length: approx. 2925 mm
Width/depth: approx. 1195 mm
Height: approx. 1930 mm
Weight: approx. 2470 kg
Work Area
Centre height: 260 mm
Distance between centres: 1600 mm
Swing over bed: 520 mm
Swing over cross slide: 324 mm
Bed width: 350 mm
Speed Range
Number of speed ranges: 2 x 3 steps
Speed range: 12 – 1800 rpm
Electrical Data
Output (motor power): 7.5 kW
Total connected load: 5.5 kW
Connection voltage: 400 V
Frequency: 50 Hz
Coolant system
Coolant pump output: 60 W
Data generated: usage data
Tailstock
Morse taper: MT 5
Quill stroke: 180 mm
Quill diameter: 72 mm
Spindle
Spindle mounting: Camlock DIN ISO 702-2 No. 8
Spindle bore/bar capacity: 80 mm
Tool post: SWH 7C
Spindle taper: MT 7
Thread Cutting
Metric pitches: 0.5 – 15 mm/rev
Number of metric pitches: 55
Inch pitches: 60 – 2 TPI
Number of inch pitches: 55
Diametral pitch: 120 – 4 DP
Number of diametral pitches: 55
Module threads: 0.25 – 7.5 mm x π
Number of module threads: 55
Travels
Top slide travel: 170 mm
Cross slide travel: 340 mm
Bed slide travel: 1400 mm
Feeds
Longitudinal feed range: 0.05 – 1.5 mm/rev
Number of longitudinal feeds: 55
Cross feed range: 0.025 – 0.75 mm/rev
Number of cross feeds: 55

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.