Sabit vidalama ünitesi, vidalama istasyonu

WSM Automation Schraubstation

WSM Stationary Screwdriving Unit, Screwdriving Station
Assembly of components for car radios and navigation systems, as well as testing the same.

The assembly station is surrounded by a safety enclosure.
The service doors are equipped with monitored interlocking switches.
During automatic operation, the doors are locked and can only be opened when the automatic process is stopped or in manual mode after pressing the 'Doors' button on the control panel. Automatic operation cannot be started with an open door.

Functional Sequence
The station is loaded with the pre-assembled module via the transfer conveyor.
Below, the work steps of the automatic station as a workpiece carrier (WT) passes through are described.
In normal operation, all 3 stations work in parallel.

- Positioning the WT with the pre-assembled module in St.2.1
- Lowering the carrier with the scanner and vision sensor
- Scanning of the 3 codes (front panel, front PCB, SD PCB), matching with the database
- Checking the correct latching of the FFC in the connector
- Raising the carrier and lowering the WT back onto the conveyor
- Positioning the WT with the pre-assembled module in St.2.2
- Positioning the screwdriver and fastening the front PCB
Gsdoibichjpfx Ah Tsip
- Lowering the WT back onto the conveyor
- Positioning the WT with the pre-assembled module in St.2.3
- Lowering the light protection hood and making contact, moving the carrier with the test sensors from below
- Type-dependent testing of the illumination of SD and CD slots and buttons
- Functional test of the CD eject button
- Lowering the WT back onto the conveyor > continue

If errors occur during testing, they are displayed, and if possible, can be rectified.
For this, manual mode is activated and the doors are opened. After repair and restarting automatic mode, the WT is tested again in the station.
If repair is not possible (e.g. screwing error), the WT is marked as NIO (not in order) in the controller and is not further processed.
Manual marking and removal of NIO units is also possible.

Financing through our partner bank is also available.
komplett-konzept.leasingo.de

More new and used assembly stations can be found in our shop!
International shipping rates available on request!

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.