Kullanılmış Rausch Rs3/800 satın al (1)

Durum: yeni gibi (kullanılmış), Fonksiyonellik: tamamen fonksiyonel, Üretim yılı: 2025, toplam ağırlık: 370 kg, güç: 3,5 kW (4,76 bg), giriş voltajı: 400 V, giriş frekansı: 50 Hz, broş uzunluğu: 800 mm, tornalama hızı: 3 m/dak, toplam uzunluk: 920 mm, toplam genişlik: 800 mm, toplam yükseklik: 1.950 mm, Manufacturer: Rausch (Haan/ Rhld) Model: RS 3 G/800 Machine No.: 2968/424 Year of manufacture: 1970 Weight: 370 kg Overhaul: 8/2025 by Wiemers AG Our Ref. / Machine No.: WAG 787 General / Technical data: Unused, overhauled mechanical vertical broaching machine by Rausch Tensile force: 3,000 kg (30 kN) Broaching speeds: 3 m/min and 6 m/min Return speed: 3 m/min Maximum stroke: 800 mm Maximum tool length: 1,000 mm Table size / working area: 340 mm x 220 mm / 430 mm x 310 mm Table opening: Ø 90 mm for standard broaching mandrels Workpiece diameter: unlimited (without splash guard enclosure) Dimensions (H x W x D): 1,950 mm x 820 mm x 900 mm (H = table height from floor without attachments) Motor: 3.5 kW Power supply: 400 Volt / 50 Hz Accessories / Special Features: Gedpfxsytvyxo Apqjiu - Modified drive system with geared motor and toothed belt drive - 2 broaching speeds: 3 m/min & 6 m/min - External stroke adjustment, cross-machine reproducible tool length setting system - Integrated coolant system with check valve and drain tap, as well as selector switch for automatic operation (not automatically switching in pivot mode) - Patented coolant/lubricant swivel system - 3-sided enclosed, forward-opening splash guard (without external control panel) - Machine cover below the safety door with chip protection and tool storage area - Electrical wiring laid in steel protective conduits - Electrical detection of clamping jaws (tool removal control to prevent unintentional retraction of the pull bridge) - Safety door with integrated emergency stop function - Control panel made of stainless steel sheet with permanent labelling - 4 central lubrication points for the trapezoidal spindle drive - Machine documentation Note: The machine has been completely overhauled; the machine body has been fully reconditioned. The following wear parts have been replaced: - New trapezoidal spindles and spindle nuts made from cast wear-resistant bronze - All bearings and seals have been renewed - The central drive shaft is new - The coolant system (pump, check valve, and drain tap), including the coolant/lubricant swivel system, is new - The clamping jaws are new (pull bridge additionally reinforced) - A switchable clamping jaw monitoring system has been installed (additional safety for operator & prevention of tool breakage) - A safety door with monitoring system has replaced the rubber safety guard - The tool length setting system has been relocated outside the machine enclosure - Additional end position limit switches have been installed - The entire electrical system (control cabinet) with Siemens components is new - Control panel made of stainless steel with permanent labelling - New SEW geared motor with toothed belt drive - The machine has been newly painted with a 2-component structured paint The machine is stored at our warehouse and can be inspected under power on site.